Differences

This shows you the differences between two versions of the page.

--- wiki:quickstart:quickstart_ifemto [2022/10/24 08:56]
ehe [Network setup]
+++ wiki:quickstart:quickstart_ifemto [2022/10/24 09:00] (current)
ehe [Network setup]
@@ Line 84: / Line 84: @@
 <note important>If this feature is enabled or disabled, don't forget to save the modification.</note>
+++++
+++++ WiFi AP connection |
+A WiFi access point is available at boot time on each Wirnet™ iFemtoCell for one hour, broadcasting an SSID named after its serial number (''klk-wifc-**XXXXXX**''). It can only be used to access the Wirnet™ iFemtoCell itself, as it does not route traffic to anywhere and does not serve as an Internet wireless access point.
+The passphrase to connect to this WiFi network is the Ethernet MAC address (it can be found on the Wirnet™ iFemtoCell label), in uppercase, without spaces between the digits, e.g. ''7076FF**YYYYYY**''.
+Note that this interface does not come with a DHCP server, it is only meant to be used for the Wirnet™ iFemtoCell configuration. Your computer may take some time to get the “connected” status, and the interface will have a “limited connectivity”, which is normal. It is not possible to upgrade the gateway firmware when you are connected with the WiFi access point.
 ++++

Kerlink Helium