This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
wiki:quickstart:quickstart_ifemto [2022/10/24 08:56] ehe [Network setup] |
wiki:quickstart:quickstart_ifemto [2022/10/24 09:00] ehe [Network setup] |
||
---|---|---|---|
Line 84: | Line 84: | ||
<note important>If this feature is enabled or disabled, don't forget to save the modification.</note> | <note important>If this feature is enabled or disabled, don't forget to save the modification.</note> | ||
+ | ++++ | ||
+ | ++++ WiFi AP connection | | ||
+ | |||
+ | A WiFi access point is available at boot time on each Wirnet™ iFemtoCell for one hour, broadcasting an SSID named after its serial number (''klk-wifc-**XXXXXX**''). It can only be used to access the Wirnet™ iFemtoCell itself, as it does not route traffic to anywhere and does not serve as an Internet wireless access point. | ||
+ | |||
+ | The passphrase to connect to this WiFi network is the Ethernet MAC address (it can be found on the Wirnet™ iFemtoCell label), in uppercase, without spaces between the digits, e.g. ''7076FF**YYYYYY**''. | ||
+ | |||
+ | Note that this interface does not come with a DHCP server, it is only meant to be used for the Wirnet™ iFemtoCell configuration. Your computer may take some time to get the “connected” status, and the interface will have a “limited connectivity”, which is normal. It is not possible to upgrade the gateway firmware when you are connected with the WiFi access point. | ||
++++ | ++++ | ||