====== Network management====== ===== Network configuration ===== To setup connectivity between the Gateway and the Wanesy™ Management Cockpit, following network configuration is required: ^ Port ^ Protocol ^ Direction ^ Destination ^ Source ^ Mandatory \\ Optional ^ Comments | | 67 UDP | DHCP | out | DHCP server in local network | Gateway | Mandatory | Not mandatory if static IP is used in the network | | 68 UDP | DHCP | in | Gateway | DHCP server in local network | Mandatory | Not mandatory if static IP is used in the network | | 53 UDP | DNS | out | DNS server in local network | Gateway | Mandatory | Not mandatory if name resolution is hard-coded in gateway configuration files | | 123 UDP | NTP | out | pool.ntp.org | Gateway | Mandatory | Default destination used from KerOS 5.x. For firmware < KerOS 5.x destinations will be x.pool.ntp.org (with x = 0 to 3) | | 80 TCP | HTTP | in | | Local laptop | Optional | For local web access if needed | | 443 TCP | HTTPS | out | upgrade.wanesy.com \\ gateway.warc.wanesy.com | Gateway | Mandatory | For automatic gateway SW update, configuration and monitoring (Magic Link, ZTP, ....etc). \\ For KerOS >=4.3.3 | | 22 TCP | SSH | in | Gateway | Local laptop | Optional | For SSH access to the gateway | | | ICMP | out | 8.8.8.8 | Gateway | Mandatory | Factory default flow configured for network monitoring | | 80 TCP | HTTP | out | http://ipv4.connman.net/online/status.html | Gateway | Optional | Useful only when 2 different backhaul are used on the gateway (for example cellular backhaul and ethernet backhaul) |