This is an old revision of the document!

Reboot a gateway on Wanesy Management Cockpit

Documentation

The constraints associated to the reboot command are as follows:

The reboot command is only accessible to users with SERVICE_ADMINISTRATOR and CHANNEL_ ADMINISTRATOR roles
It is not possible to send a new reboot command if another one is already pending for the same gateway
It is possible to cancel a reboot command only if it has not yet been sent to the gateway

To reboot a gateway, you need to go to the gateway overview page and select Reboot from the ACTIONS menu.

After clicking on Reboot, you will be asked to confirm in a popup.

Once triggered, the reboot command will be sent to the gateway when the next telemetry message is received (message expected every hour).

When a reboot command is pending (waiting to be sent to the gateway), a red dot is displayed in the ACTIONS menu.

To cancel the reboot command, you need to select again Reboot from the ACTIONS menu.

Then a CANCEL REBOOT button is displayed in a popup.