• Wirnet™ iBTS : 7276FF002E<last 6 characters of the CPU serial number>
• Wirnet™ Station : 7276FF000<last 7 characters of the station barcode>
• Wirnet™ iFemtoCell : 7276FF00<last 8 characters of the CPU board serial number>

For the iFemtoCell, you can retrieve the CPU serial number with the following command:

root@klk-wifc-01AAFF:~ # grep serial_number /tmp/sys_startup_status.json 
        "serial_number": "0x4501aaff", 

• We can limit the number of gateways, the number of endpoints and number of users linked to a customer via the administration menu (only accessible for users that have SuperAdmin privileges)

• There is no limit

• Add

• An exception is raised and the process stops

• An exception is raised and the process stops when the error is encountered. All lines located before this point are taken into account by the system

• Yes

• No

• In the LNS / endpoint menu, click on your endpoint and then click to the cross at the right side of the text “FRAME COUNTER DOWN”
• select F5 for page refresh several times

⇒ Status “Uplink ok” appears and uplink message queue is updated with new messages in “Rx messages” tab

' When connected to the Wanesy™ Management Center VPN, the IP address assigned to the gateway is in the 10.8.0.0/16 subnet.

The gateway LAN subnet should not overlap with this subnet.