This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
wiki:update [2020/02/21 17:25] mgr |
— (current) | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== SPN upgrade ====== | ||
- | <note important> | ||
- | This page concern the firmware upgrade. It is only dedicated to gateways with the SPN firmware already installed. | ||
- | </note> | ||
- | |||
- | ===== From firmware 2.0.3 ===== | ||
- | |||
- | From firmware 2.0.3 upgrade can be triggered from: | ||
- | * USB | ||
- | * HTTP rest | ||
- | * FTP server | ||
- | * Web interface | ||
- | |||
- | Consult the [[wiki:resources|user guide]] for more information. | ||
- | |||
- | To update from SPN with data loss (recommended) (SPN already installed): | ||
- | liveburner_x.y.z-spn_klk-wifc.ipk.gpg | ||
- | |||
- | To install from SPN without data loss (SPN already installed): | ||
- | fwupgrade_x.y.z-spn_klk-wifc.ipk.gpg | ||
- | |||
- | Upgrade files are available in the firmware [[wiki:resources#spn_firmware_to_install_spn|resources]] pages. | ||
- | |||
- | <note important> | ||
- | Once the loading bar is full, a few seconds are required to see the //reboot station// button. | ||
- | </note> | ||
- | |||
- | ==== Impacts on your network ==== | ||
- | |||
- | * Configuration parameters are not impacted by the firmware upgrade **except the RX configuration parameters**. LoRa RX parameters need to be reconfigured after the upgrade. | ||
- | * Tx power may be lost after upgrade | ||
- | * Fleet configuration is not impacted by the firmware upgrade. | ||
- | * All SPN parameters and the fleet can be uploaded/downloaded (in JSON formated files) to configure/backup the gateway. | ||
- | * If an upgrade is triggered, these files will have to be regenerated to comply with the new firmware. |