Wanesy™ SPN (End Of Life)

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Quick Start ======

This section aims to guide a user through the main steps of the configuration of the SPN firmware.
In this quickstart, the user will start with a freshly installed software with no configuration and end with an end-device sending data to SPN.

Prerequisites:
  * SPN is already installed on an iFemtoCell
  * The SPN license file of this iFemtoCell
  * The iFemtoCell is connected to a network with a __DHCP server__ and a __DNS server__
  * Chrome is used to connect to web interface


===== Web interface login =====
The home web interface is accessible at the following address: 
''http://klk-wifc-XXXXXX/''
Where XXXXX are the 6 digits at the end of hostname/board id . 

Example: 
The address to be used with the iFemtoCell owning the following label is: ''http://klk-wifc-03002e/'' (case insensitive)

{{ :wiki:label_ifemtocell_v1.0.jpg?nolink&400 |}}

  * Connect to the web interface

The default login/password are:\\
user: ''spn''\\
password: ''spnpwd''

===== License installation =====
Installing the SPN software is not sufficient to use it. It also needs to be activated with a license file.

  * Go to the //License// tab under the //Administration// menu.
  * Either click on the panel and choose the license TXT file, or drag and drop it.

//A valid license file contains 32 hexadecimal characters// 

===== Password update =====
For security reasons, Kerlink strongly advises its customers to change the default password.

  * Go to the //Station// tab under the //Administration// menu and change the password.

===== Regional parameters configuration =====
The region where the station will be used needs to be configured.

  * Go to the //Region// menu and choose your region.
  * Validate the modification with the //save configuration// button.

===== Rx configuration =====
The iFemtoCell cannot listen to every frequencies simultaneously. Up to 8 frequencies can be listened.
The frequencies to be listened need to be configured. 

To understand how the frequency configuration works, it is necessary to know that the gateways' hardware contains two RF frontends. Each of these frontends has a 0.8 MHz Bandwidth. Thus, all 8 channels must be contained within these two 0.8 MHz intervals.

//Not all the channels are necessarily used.// 

Example of typical configuration:
{{ :wiki:typical_rx_config_v1.0.png?nolink |}}
 
//All 8 frequencies can be contained within one 0.8MHz interval.//
 
{{ :wiki:one_bandwitdth_rx_config_v1.0.png?nolink |}}

  * Go to the //Rx Configuration// menu and choose your region.
  * Enter the center frequencies of both frontends.
  * Enter the frequencies that your end-device uses.
  * Validate the modification with the //save configuration// button

===== End-device registration =====
Before receiving data from the end-device, it first needs to be registered.

  * Go to the //manage endpoints// tab under the //Endpoints// menu.
  * Fill the information of your endpoint. //If you are not in Europe, you will probably have to use the Override default Rx parameters//
  * Validate the end-device with the //add endpoint// button

===== Data reception====
The (basic) configuration is over.
  * Go to the //Received data// menu. //You can refresh the received packets with the refresh button at the bottom right corner of the page.//
Wanesy™ SPN (End Of Life)

User Tools

Site Tools

Page Tools
