SPN firmware v2.1.2 (February 2020)

SPN firmware v2.1.2 (February 2020)

Changes from 2.0.3

New features

Compatible with Wirnet iFemtoCell-evolution gateway
Compatible with Wirnet iStation gateway
Node-RED available
Support of Fujisoft FS040U dongle

Evolutions

Web user interface features fit to licence
No more restrictions on SSH access

Bug fixes

[SMS utils] SMS: multiple answers received
[Web user interface] Crash with web user interface
[Remote HTTP] Relax the validation rules to the push URL
[System/Wi-Fi] Support for spaces in WPA PSK

Restrictions

[System]: Wirnet iFemtoCell SPN pass on WiFi connection only if we unplug the ethernet wire.
[System]: getOpenVPNConfiguration returns only “enable”.
[System]: Halt on iFemtoCell SPN doesn't really stop the iFemtoCell. It reboots after a few seconds/minutes.
[System]: When switched off, the WiFi radio power is not truly powered off.
[LoRa]: Cannot create end-device immediately after a switch from region Australia 915-928 to AS 923MHz.
[LoRa]: Status is always “UNKNOWN” in the fleet.
[LoRa]: Cannot declare an OTAA end-device starting with multiple 0 (e.g. 0000000000112233) if an ABP end-device has the same name (00112233).
[LoRa]: End-devices sequence numbers are reset if the end-devices are restarted.
[LoRa]: Change of network_id do not reject frames of a end-device that don't perform a new join.
[LoRa]: FSK is not supported with data rate 7.
[LoRa]: DR6 SF7-BW250 for RX2 data rate is not available for Asia and Japan Region.
[LoRa]: MonoSF drift from radio x central frequency is reduce from 400kHz to 300kHz.
[LoRa]: Possible to set Tx power higher than 23 dBm in Korea Region.
[WEB user interface]: When the timezone is changed, a reboot is needed to apply the configuration in the log files.
[WEB user interface]: Network parameters are lost when a network interface is turned off on WEB interface.
[WEB user interface]: Reset configuration is too slow, nothing happens before 30s - 60s.

Compatibility

Hardware

No known issues on various hardware product versions

Software

Gateway model	KerOS firmware version	SPN firwmare version
Wirnet iFemtoCell	From 3.1.14	2.0.3
Wirnet iStation	From 4.2.2	Not applicable
Wirnet iFemtoCell-evolution	From 4.2.2	Not applicable

LoRaWAN

Compatible with LoRaWAN Specification V1.0.2
Compatible with LoRaWAN Regional Parameters V1.1

Download

To install from SPN with data loss (recommended) (SPN FW already installed):
liveburner_2.1.2-spn_klk-wifc.ipk.gpg md5: 518611b4f1f97fc7b7bb105703325ae4.

To install from SPN without data loss (SPN FW already installed):
fwupgrade_2.1.2-spn_klk-wifc.ipk.gpg md5:8546dee6f19773942987a83f12ec7559

To install from KerOS (SPN FW not installed yet):
liveburner_2.1.2-spn_klkgw-signed.ipk md5:483a91bdce2c2b6328cb45fe7d99d17b

To check MD5 you can use Powershell command below :

Get-FileHash liveburner_2.1.2-spn_klkgw-signed.ipk -Algorithm MD5

Table of Contents