wiki:firmware:installation
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
wiki:firmware:installation [2020/07/09 16:09] mbi |
wiki:firmware:installation [2023/01/24 14:40] (current) rco [With web interface recommended] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== Wanesy™ SPN firmware installation ====== | + | ====== Wanesy™ SPN firmware installation from KerOS firmware ====== |
| By default, Wanesy SPN firmware is not installed on Kerlink gateways. Therefore, to install the Wanesy SPN the following steps are required: | By default, Wanesy SPN firmware is not installed on Kerlink gateways. Therefore, to install the Wanesy SPN the following steps are required: | ||
| Line 30: | Line 30: | ||
| | **Wirnet iFemtoCell-evolution** | 4.2.1 and above | | | **Wirnet iFemtoCell-evolution** | 4.2.1 and above | | ||
| + | |||
| + | <note warning>Installation of SPN firmware from version 5.X is not possible. You will have to downgrade from 5.X to 4.3.3-2. You can download the firmware 4.3.3-2 on [[https://wikikerlink.fr/wirnet-productline/doku.php?id=wiki:firmware:lastversion#download|this page]]</note> | ||
| * If the firmware is not the expected one, upgrade it. | * If the firmware is not the expected one, upgrade it. | ||
| Line 82: | Line 84: | ||
| - Drag & drop your SPN ipk file and click on UPDATE GATEWAY. | - Drag & drop your SPN ipk file and click on UPDATE GATEWAY. | ||
| - A reboot is required to finalize the update, click on REBOOT GATEWAY. | - A reboot is required to finalize the update, click on REBOOT GATEWAY. | ||
| + | - To use fix IP address check [[https://wikikerlink.fr/wanesy-spn/doku.php?id=wiki:webui:administration:network#ethernet_configuration_fixed_ip_address|Fixed IP]] | ||
| <note important> | <note important> | ||
wiki/firmware/installation.1594303772.txt.gz · Last modified: 2020/07/09 16:09 by mbi
Page Tools
