This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
wiki:firmware:lastversion [2022/07/26 14:03] ehe |
wiki:firmware:lastversion [2022/12/08 14:39] cgu [Wi-Fi: firmware update] |
||
---|---|---|---|
Line 47: | Line 47: | ||
===== Download ===== | ===== Download ===== | ||
- | ==== Wi-Fi: firmware update ==== | + | ==== Wi-Fi: Firmware update ==== |
+ | <note warning>Please check your firmware version before updating and follow the instructions in the corresponding section</note> | ||
=== Installed firmware is v1.9.0 or higher version === | === Installed firmware is v1.9.0 or higher version === | ||
Line 55: | Line 55: | ||
=== Installed firmware is v1.8.0 or lower version === | === Installed firmware is v1.8.0 or lower version === | ||
- | If the installed firmware is v1.8.0 or lower version, firmware update procedure must respect the specific order described below (update STM32 first): | + | If the installed firmware is v1.8.0 or lower version, the firmware update procedure must respect the specific order described below (**<fc #ff0000>update STM32 first</fc>**): |
<note important> | <note important> | ||
^ steps ^ STM32 version ^ ESP32 version ^ SSID ^ Actions ^ | ^ steps ^ STM32 version ^ ESP32 version ^ SSID ^ Actions ^ | ||
- | | #1 | v1.7.0/v1.8.0 | v1.7.0/v1.8.0 | optout_klk/wave_xxxx | Place product away from wall or table (ie. perpendicular is OK, parallel is KO)| | + | | #1 | v1.7.0/v1.8.0 | v1.7.0/v1.8.0 | optout_klk/wave_xxxx | **Place product upright away from wall or table**| |
|:::|:::|:::|:::|Upload STM32 v2.0.1 image| | |:::|:::|:::|:::|Upload STM32 v2.0.1 image| | ||
|:::|:::|:::|:::|Wait until green LED is back ON (ie. no longer blinking)| | |:::|:::|:::|:::|Wait until green LED is back ON (ie. no longer blinking)| |