wiki:setup:setup_wave
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
wiki:setup:setup_wave [2021/10/15 14:41] dlr [Documentation] |
wiki:setup:setup_wave [2022/10/18 12:22] cgu [Update the firmware] |
||
|---|---|---|---|
| Line 8: | Line 8: | ||
| * Leaflet: {{:documentation:Kerlink_Wanesy-Wave-Commercial-Leaflet_v1.5.pdf |}}\\ | * Leaflet: {{:documentation:Kerlink_Wanesy-Wave-Commercial-Leaflet_v1.5.pdf |}}\\ | ||
| * Quickstart guide: {{:documentation:Kerlink_Wanesy-Wave_Quick-start-guide_v1.2.pdf |}}\\ | * Quickstart guide: {{:documentation:Kerlink_Wanesy-Wave_Quick-start-guide_v1.2.pdf |}}\\ | ||
| - | * Technical Product description: {{:documentation:E-CON-Wanesy_Wave_Product_Description-V1.4.pdf |}} \\ | + | * Technical Product description: {{:documentation:E-CON-Wanesy_Wave_Product_Description-V1.4.pdf |}}\\ |
| - | * Interface documentation: {{:documentation:e-con-wanesy_wave_interfaces-v1.1.pdf | e-con-wanesy_wave_interfaces-v1.1.pdf }}. \\ | + | * Interface documentation: {{:documentation:e-con-wanesy_wave_interfaces-v1.3.pdf |}}\\ |
| * WiFi update: {{:documentation:E-CON-Wanesy_Wave_FW_Update_WiFi_V1.2.pdf |}}\\ | * WiFi update: {{:documentation:E-CON-Wanesy_Wave_FW_Update_WiFi_V1.2.pdf |}}\\ | ||
| Line 18: | Line 18: | ||
| The connection of the Wanesy Wave to a LoRaWAN network can be done by following steps below: | The connection of the Wanesy Wave to a LoRaWAN network can be done by following steps below: | ||
| - | - Retrieve the Wanesy Wave LoRaWAN credentials (DevEUI, AppEUI, AppKey). Those can be requested to support@kerlink.fr by providing the Wanesy Wave "Product ID". | + | - Retrieve the Wanesy Wave LoRaWAN credentials (DevEUI, AppEUI, AppKey). Those can be requested to **your supplier** by providing the Wanesy Wave Product ID. |
| - Declare the Wanesy Wave on the LoRa Network Server (OTAA join procedure). | - Declare the Wanesy Wave on the LoRa Network Server (OTAA join procedure). | ||
| - Install the Wanesy Wave in a LoRaWAN gateway coverage field, properly configured with the LoRa Network Server. | - Install the Wanesy Wave in a LoRaWAN gateway coverage field, properly configured with the LoRa Network Server. | ||
| Line 55: | Line 55: | ||
| * Wi-Fi firmware update is the preferred method. | * Wi-Fi firmware update is the preferred method. | ||
| + | * It's recommended to connect the device to an LNS to get the access point. | ||
| * Please refer to proper documentation //Wi-Fi update// available in the //Documentation// section: [[wiki:setup:setup_wave#documentation|click here]]. | * Please refer to proper documentation //Wi-Fi update// available in the //Documentation// section: [[wiki:setup:setup_wave#documentation|click here]]. | ||
wiki/setup/setup_wave.txt · Last modified: 2024/03/22 11:20 by ehe
Page Tools
