wiki:installation_ibts
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
wiki:installation_ibts [2019/01/17 10:01] 127.0.0.1 external edit |
— (current) | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== Wirnet™ iBTS installation recommendations ====== | ||
| - | The detailed installation procedure is described in the "Installation and Maintenance manual" available from the [[resources_ibts:resources#documentations|resources]] page. This procedure must be read, the integrity of the gateway, its warranty and its efficiency depend on it. | ||
| - | |||
| - | Here are the key factors of a good installation (it does not prevent you from reading the "installation and maintenance manual"), plus a few additional recommendations: | ||
| - | |||
| - | * For antenna links (GNSS, LTE) and LoRa antenna links, RF coaxial surge protection are recommended. | ||
| - | * Surge protection must be positioned as close as possible to the gateway. | ||
| - | * A good earthing of the whole installation is required. | ||
| - | * Used ground connection cables must be as short as possible (<30cm, 4sq.mm). | ||
| - | * Using of a lightning rod on the top of the mast is strongly recommended. | ||
| - | * It is recommended to regroup all ground connections toward the mast at one point (at least mounting bracket + surge protections). This point must be as close as possible to the product. | ||
| - | * Recommended shielding Ethernet cable is category 6A, STP or SSTP. | ||
| - | * Before any product installation, a full spectrum analysis should be done on the field with a spectrum analyser. A backup of each measurement is strongly recommended in case further analysis is required. | ||
| - | * Photos of the full installation are also recommended to memorize antennas co-locations and check if the installation is properly done. | ||
wiki/installation_ibts.1547715696.txt.gz · Last modified: 2019/09/25 15:26 (external edit)
