wiki:installation_ifemto
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
wiki:installation_ifemto [2018/12/14 12:07] hch |
— (current) | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== Wirnet™ iFemtoCell installation recommendations ====== | ||
| - | The detailed installation procedure is described in the "Installation and maintenance manual" available from the [[resources_ibts:resources#wirnet_ibts_installation_and_maintenance|resources]] page. This procedure must be read, the integrity of the gateway, its warranty and its efficiency depend on it. | ||
| - | |||
| - | Here are the key factors of a good installation (it does not prevent you from reading the "Installation and maintenance manual"), plus a few additional recommendations:\\ | ||
| - | FIXME | ||
| - | * Gateway must be mounted on any concrete pedestal, concrete wall or any non-flammable surface (UL94-V0). | ||
| - | * The LTE/HSPA/GPRS connection requires a USIM subscription and an optional USB dongle. | ||
| - | * Before inserting the USIM card, pay attention that the Wirnet iFemtoCell is unpowered by checking that all LEDs are OFF. | ||
| - | * To optimize the colocation between the USB WAN dongle and the external LoRa antenna, a distance of 1m is required between both radiated parts. | ||
| - | * It is recommended to use a 1 meter extension cable for LoRa antenna when an USB WAN doncgle is used. | ||
| - | * In harsh environment, especially if antenna link (LoRa) is placed in outdoor conditions, RF coaxial surge protection must be used. | ||
| - | * In harsh environment, especially if Ethernet link is placed in outdoor conditions, an indoor Ethernet surge protection must be used. | ||
| - | * A good earthing of the whole installation is required. | ||
| - | * Used ground connection cables must be as short as possible (<30cm, 4sq.mm). | ||
| - | * It is recommended to regroup all ground connections at one point (surge protections). This point must be as close as possible to the product. | ||
| - | * Recommended shielding Ethernet cable is category 6A, STP or SSTP. | ||
| - | * Before any product installation, a full spectrum analysis should be done on the field with a spectrum analyzer. A backup of each measurement is strongly recommended in case further analysis is required. | ||
| - | * Photos of the full installation are also recommended to memorize antennas co-locations and check if the installation is properly done. | ||
wiki/installation_ifemto.1544785633.txt.gz · Last modified: 2019/01/17 10:01 (external edit)
