wiki:lora:basic_station_forwarder
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
wiki:lora:basic_station_forwarder [2025/01/15 10:31] vsz |
wiki:lora:basic_station_forwarder [2025/05/21 09:12] (current) ehe [Kerlink CUPS configuration] |
||
|---|---|---|---|
| Line 94: | Line 94: | ||
| </code> | </code> | ||
| ++++ | ++++ | ||
| + | ==== Kerlink CUPS configuration ==== | ||
| + | <note important>Only available since [[bspf_v3.3.0|Basic Station Packet Forwarder 3.3.0]]</note> | ||
| - | ==== Configuration ==== | + | After installation Kerlink Basic Station Packet Forwarder is disabled by default. |
| + | Once Basic Station Packet Forwarder started, if no configuration is available, it will connect to Kerlink CUPS using: | ||
| + | * cups-boot.uri | ||
| + | * cups-boot.key | ||
| + | * cups-boot.crt | ||
| + | |||
| + | Once connected to Kerlink CUPS, Basic Station Packet Forwarder will get its CUPS/LNS configuration. | ||
| + | |||
| + | It's now possible to set LNS configuration using Cockpit: [[https://cockpit.docs.kerlink.com/en/update-config/configure-lorawan|Configure LoRaWAN with Wanesy Management Cockpit]] | ||
| + | |||
| + | ==== Manual configuration ==== | ||
| Once installed, Kerlink Basic Station Packet Forwarder is disabled by default. It should first be configured for the wanted server (CUPS and/or LNS). | Once installed, Kerlink Basic Station Packet Forwarder is disabled by default. It should first be configured for the wanted server (CUPS and/or LNS). | ||
wiki/lora/basic_station_forwarder.1736933489.txt.gz · Last modified: 2025/01/15 10:31 by vsz
