Wirnet™ i-series

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== Wirnet™ iBTS installation recommendations ======

The detailed installation procedure is described in the "Installation and Maintenance manual" available from the [[resources_ibts:resources#documentations|resources]] page. This procedure must be read, the integrity of the gateway, its warranty and its efficiency depend on it.

Here are the key factors of a good installation (it does not prevent you from reading the "installation and maintenance manual"), plus a few additional recommendations:

  *  For antenna links (GNSS, LTE) and LoRa antenna links, RF coaxial surge protection are recommended.
  *  Surge protection must be positioned as close as possible to the gateway.
  *  A good earthing of the whole installation is required.
  *  Used ground connection cables must be as short as possible (<30cm, 4sq.mm).
  *  Using of a lightning rod on the top of the mast is strongly recommended.
  *  It is recommended to regroup all ground connections toward the mast at one point (at least mounting bracket + surge protections). This point must be as close as possible to the product.
  *  Recommended shielding Ethernet cable is category 6A, STP or SSTP.
  *  Before any product installation, a full spectrum analysis should be done on the field with a spectrum analyser. A backup of each measurement is strongly recommended in case further analysis is required.
  *  Photos of the full installation are also recommended to memorize antennas co-locations and check if the installation is properly done.

Wirnet™ i-series

User Tools

Site Tools

Page Tools