Wirnet™ i-series

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Wirnet™ iStation: Connect to the gateway ======

Detailed instructions about Wirnet iStation installation and maintenance are available on the [[wiki:resources:resources#documentation|Resources and documentation page]].

===== Power supply the iStation =====

The Wirnet iStation gateway is powered with a PoE injector. Please see section 3.3 of [[wiki:resources:resources#documentation|Wirnet™ iStation Product Description]] for more information.

Connect the PoE output connector to the Ethernet port on the bottom side of the gateway.

{{:images:istation_gland_poe.jpg?300|}}

The iStation should power on, showing a solid green LED, accompanied by a red LED starting solid, then blinking during bootup.

===== Connect through the network =====

Please see the [[wiki:systeme_mana:connection_credentials|connection, login and credentials page]] for more information on how to connect to your iStation.

===== Connect using the debug probe =====
Wirnet™ Debug Probe is the only compatible debug probe.

==== Connection ====

Plug Wirnet Debug probe on your gateway Type-C connector from one side and on USB connector of your computer on the other side as explained in Wirnet Debug probe quickstart.


{{:images:debug_probe_istation_term.png?450 |}} {{:images:debug_probe_istation_gw.png?505|}}


Once plugged correctly:
  * Green equipment led on Debug probe should be ON (equipment «power» led remote display).
  * Serial port led (on PC side) should be ON (or blink if communication is on-going between equipment and terminal)
  * USB Type-A connector should be usable to plug a USB stick (Wirnet Debug probe can also be used as adapter without connection to a computer).

==== Windows installation ====

  - Download the [[http://www.ftdichip.com/Drivers/VCP.htm|ftdi drivers]] for the debug probe 
  - Install the drivers

==== Linux installation ====

On Linux, everything should work out of the box. The serial port will be located in ''/dev/ttyUSB*''.


==== Connection to the Wirnet™ iStation ====
  - Open a serial terminal (HyperTerminal, PuTTY, Teraterm, GNU screen, minicom, etc.)
  - Select the serial port created by the FTDI driver (usually: ''COM3'' on Windows, ''/dev/ttyUSB0'' on Linux)
  - Apply the following parameters to use your serial connection:
     * baud rate : ''115200''
     * data length : ''8''
     * parity : ''none''
     * stop bit : ''1''
     * flow control : ''none''
  - Enter your credentials in the command prompt:
     * login: ''root''
     * password: ''pdmk-$serialno''
''pdmk-**$serialno**'' is the default password on the gateway. See [[wiki:systeme_mana:connection_credentials#default_password|here for more information]]. In case of failure, request password to [[support@kerlink.fr]].
Wirnet™ i-series

User Tools

Site Tools

Page Tools
