FAQ - Gateway Software Installation for WMC >= 3.2

This procedure is the First Install procedure.
It must be performed from scratch (only FW is available - the gateway is not connected to the WMC)

Follow this procedure or use the magic link:

1. Ask for a new OpenVPN packages to the support@kerlink.fr team and give the serial number of your gateway
2. Install the gateway software by following the procedure described here: Wirnet i-series software release 4.3.3
3. Install the OpenVPN packages on your gateway (as any other package, see the link for software upgrade below)
4. Enable the embedded WMC application (click here to see how to use klk_apps_config)
5. Wait a short time and check that the gateway is connected to the WMC 3.x

The software update procedure is defined above:

Wirnet i-series (iBTS, iFemtoCell, iStation, iFemtoCell-evolution):http://wikikerlink.fr/wirnet-productline/doku.php?id=wiki:keros_custo:sw_updates

The magic link can also be used for a first install process. Follow this link to perform this.

Follow this procedure or use the magic link:

1. Ask for a new OpenVPN packages to the support@kerlink.fr team and give the serial number of your gateway
2. Install the OpenVPN packages on your gateway (as any other package, see the link for software upgrade below)
3. Install the gateway software by following the procedure described here: FAQ - Gateway Upgrade for WMC 3.x
4. Wait a short time and check that the gateway is connected to the WMC 3.x

The software update procedure is defined above:

Wirnet i-series (iBTS, iFemtoCell, iStation):http://wikikerlink.fr/wirnet-productline/doku.php?id=wiki:keros_custo:sw_updates

The magic link can also be used for a first install process. Follow this link to perform this.