• Compatible with Wirnet iFemtoCell-evolution gateway
• Compatible with Wirnet iStation gateway
• Node-RED available
• Support of Fujisoft FS040U dongle

• Web user interface features fit to licence
• No more restrictions on SSH access

• [SMS utils] SMS: multiple answers received
• [Web user interface] Crash with web user interface
• [Remote HTTP] Relax the validation rules to the push URL
• [System/Wi-Fi] Support for spaces in WPA PSK

• [System]: Wirnet iFemtoCell SPN pass on WiFi connection only if we unplug the ethernet wire.
• [System]: getOpenVPNConfiguration returns only “enable”.
• [System]: Halt on iFemtoCell SPN doesn't really stop the iFemtoCell. It reboots after a few seconds/minutes.
• [System]: When switched off, the WiFi radio power is not truly powered off.
• [LoRa]: Cannot create end-device immediately after a switch from region Australia 915-928 to AS 923MHz.
• [LoRa]: Status is always “UNKNOWN” in the fleet.
• [LoRa]: Cannot declare an OTAA end-device starting with multiple 0 (e.g. 0000000000112233) if an ABP end-device has the same name (00112233).
• [LoRa]: End-devices sequence numbers are reset if the end-devices are restarted.
• [LoRa]: Change of network_id do not reject frames of a end-device that don't perform a new join.
• [LoRa]: FSK is not supported with data rate 7.
• [LoRa]: DR6 SF7-BW250 for RX2 data rate is not available for Asia and Japan Region.
• [LoRa]: MonoSF drift from radio x central frequency is reduce from 400kHz to 300kHz.
• [LoRa]: Possible to set Tx power higher than 23 dBm in Korea Region.
• [WEB user interface]: When the timezone is changed, a reboot is needed to apply the configuration in the log files.
• [WEB user interface]: Network parameters are lost when a network interface is turned off on WEB interface.
• [WEB user interface]: Reset configuration is too slow, nothing happens before 30s - 60s.

• No known issues on various hardware product versions

• Compatible with LoRaWAN Specification V1.0.2
• Compatible with LoRaWAN Regional Parameters V1.1

To install from SPN with data loss (recommended) (SPN FW already installed):
liveburner_2.1.2-spn_klk-wifc.ipk.gpg md5: 518611b4f1f97fc7b7bb105703325ae4.

To install from SPN without data loss (SPN FW already installed):
fwupgrade_2.1.2-spn_klk-wifc.ipk.gpg md5:8546dee6f19773942987a83f12ec7559

To install from KerOS (SPN FW not installed yet):
liveburner_2.1.2-spn_klkgw-signed.ipk md5:483a91bdce2c2b6328cb45fe7d99d17b

To check MD5 you can use Powershell command below :

Get-FileHash liveburner_2.1.2-spn_klkgw-signed.ipk -Algorithm MD5