Introduction
Firmware management:
LoRa network management
Interfaces:
Gateway administration
Support and resources:
User Tools
Sidebar
wiki:update
This is an old revision of the document!
Table of Contents
SPN upgrade
This page concern the firmware upgrade. It is only dedicated to gateways with the SPN firmware already installed.
From firmware 2.0.3
From firmware 2.0.3 upgrade can be triggered from:
- USB
- HTTP rest
- FTP server
- Web interface
Consult the user guide for more information.
To update from SPN with data loss (recommended) (SPN already installed): liveburner_x.y.z-spn_klk-wifc.ipk.gpg
To install from SPN without data loss (SPN already installed): fwupgrade_x.y.z-spn_klk-wifc.ipk.gpg
Upgrade files are available in the firmware resources pages.
Once the loading bar is full, a few seconds are required to see the reboot station button.
Impacts on your network
- Configuration parameters are not impacted by the firmware upgrade except the RX configuration parameters. LoRa RX parameters need to be reconfigured after the upgrade.
- Tx power may be lost after upgrade
- Fleet configuration is not impacted by the firmware upgrade.
- All SPN parameters and the fleet can be uploaded/downloaded (in JSON formated files) to configure/backup the gateway.
- If an upgrade is triggered, these files will have to be regenerated to comply with the new firmware.
wiki/update.1584365180.txt.gz · Last modified: 2020/03/16 14:26 by ghi
