Introduction
Firmware management:
LoRa network management
Interfaces:
Gateway administration
Support and resources:
User Tools
Sidebar
wiki:webui:configuration:lora_network
Table of Contents
LoRa network ID
The Configuration ⇒ LoRa network ⇒ LoRa network page only allow to choose your LoRa NwkID. The LoRa NwkID is applicable only for an OTAA fleet.
NwkID range value: 0-127.
After changing the network ID, a reboot of the gateway is needed.
Be careful, once
NwkID is updated, OTAA devices already activated must initiate another join procedure to communicate again with the new NwkID
Kerlink recommends to configure the LoRa NwkID before adding your end-devices to the fleet.
wiki/webui/configuration/lora_network.txt · Last modified: 2020/03/13 15:36 by ghi
