• Add possibility to disable NewChannelReq/LinkADRReq MAC commands

• [Node RED] Flows stopped due to missing node types zeromq In/Out Warning: the issue with ZeroMQ node is fixed but it may fail again for various reasons (dependency issues, prebuilt package unavailable) when updating or installing another node.
• [Lora]:By default, Tx power is not correct
• [Lora]:Default RX2 data rates is not correct for AS923
• [Lora]:No more uplink data from end device once 1st NewChannelReq/LinkADRReq sent
• [Lora]:SPN LNS has an issue with ACK field management on LinkCheckAns: 6 attempts
• [Lora]:Downlink ACKs don't work in AU915 with confirmed uplinks
• [Lora]:Sometimes, LinkADRReq is sent several times in a raw

• [Lora]:No LinkADRReq sent with MAC Command disabled but ADR enabled in US915 (and possibly in AU915)
• [Lora]:FCnt Down are not increasing linearly when MAC command enabled
• [Lora]:Force RX2 window in KR920 & IN865 does not work
• [Lora]:First DataDown is not sent properly in ClassC
• [Lora]:Impossible to send DataDown after the first uplink
• [Lora]:Channel mask is not correct when no channel management
• [Lora]:MonoSF channel is not set in ChMask

• This firmware can be used on several Kerlink products:

  iFemtoCell (serial number: 0x39XXXXXX (868), 0x44XXXXXX (915), 0x45XXXXXX (923))
  iStation (all versions except V1A) (serial number: 0x54XXXXXX (923), 0x55XXXXXX (915), 0x56XXXXXX (868))
  iFemtoCell Evolution (serial number: 0x64XXXXXX (868), 0x65XXXXXX (915), 0x66XXXXXX (923))

• Compatible with LoRaWAN Specification V1.0.2
• Compatible with LoRaWAN Regional Parameters V1.1

OPKG package and GPG signed to upgrade from 2.0.3 and keep SPN data/configuration:
fwupgrade_2.3.2-spn_klk-wifc.ipk.gpg md5: 8546dee6f19773942987a83f12ec7559.

OPKG package and GPG signed to upgrade from 2.0.3 but without keeping the SPN data/configuration:
liveburner_2.3.2-spn_klk-wifc.ipk.gpg md5: 151bd4c28a3846c1560132db7fbf1673.

OPKG package to upgrade from 2.1.2 and keep SPN data/configuration:
keros_2.3.2-spn_klkgw-signed.ipk md5: 58b1a876ccaaa76560b8b8a41a45f43d.

OPKG package to install from a KerOS firmware or upgrade from 2.1.2 without keeping the SPN data/configuration:
liveburner_2.3.2-spn_klkgw-signed.ipk md5: b0ef37ae771b2e4c00af994e8b1f3290.

To check MD5 you can use Powershell command below :

Get-FileHash keros_2.3.2-spn_klkgw-signed.ipk -Algorithm MD5