This release is compatible with the following Wanesy Wave revision:
STM32 MCU :
To update the firmware, follow instruction on the Firmware update section of the Setup page: click here.
ESP32 MCU:
To update the firmware, follow instruction on the Firmware update section of the Setup page: click here.
Regular firmware update can be followed (update ESP32 first), please read e-con-wanesy_wave_fw_update_wifi_v1.2.pdf available in the Wanesy™ Wave Setup: Documentation section.
If the installed firmware is v1.8.0 or lower version, firmware update procedure must respect the specific order described below (update STM32 first):
| steps | STM32 version | ESP32 version | SSID | Actions |
|---|---|---|---|---|
| #1 | v1.7.0/v1.8.0 | v1.7.0/v1.8.0 | optout_klk/wave_xxxx | Place product upright away from wall or table |
| Upload STM32 v2.0.1 image | ||||
| Wait until green LED is back ON (ie. no longer blinking) | ||||
| #2 | v2.0.1 | v1.7.0/v1.8.0 | optout_klk/wave_xxxx | Verify STM32 version in device_info.txt file |
| Upload ESP32 v2.0.1 image | ||||
| #3 | v2.0.1 | v2.0.1 | wave_xxxx | Verify ESP32 version in esp32_version.txt file (displayed version is 2.0.0) |
stm32_wanesywave_EU868_v2.0.1_DAcde.kbin (md5: 3664abb6d9f17425ca10a8ac7117e0a7).esp32_firmware_v2.0.1.bin (md5: 164e005e7453b7a7ee660fa973b2c437).stm32_wanesywave_US915_v2.0.1_DBcdef.kbin (md5: 3bf899586556161ca71fff4fc08c2c94).esp32_firmware_v2.0.1.bin (md5: 164e005e7453b7a7ee660fa973b2c437).