Introduction
Firmware management:
LoRa network management
Interfaces:
Gateway administration
Support and resources:
Introduction
Firmware management:
LoRa network management
Interfaces:
Gateway administration
Support and resources:
This is an old revision of the document!
Check your license version
SRVLIC-SPN00 SPN V1 for Wirnet Station SRVLIC-SPN01 SPN V1 for Wirnet Ifemtocell SRVLIC-SPN2* SPN V2 for Wirnet Ifemtocell / iStation / Ifemtocell-Evolution
If you have SRVLIC-SPN01 SPN V1 for Wirnet Ifemtocell gateway you must use the following Wiki: Wirnet iFemtocell SPN.
If you have SRVLIC-SPN00 SPN V1 for Wirnet Station gateway you must use the following Wiki: IoT Station SPN.
This section aims to guide a user through the main steps of the configuration of the Wanesy SPN firmware in order to receive data from an end-device.
Prerequisites:
To use an end-device with Wanesy SPN, the end-device and the gateway need to use the same LoRa configuration. Some parameters are common to the entire fleet and some parameters are end-device specific.
Ethernet is available on all gateways but Wi-Fi only available on iFemtoCell model.
If ethernet is used, the gateway needs DHCP and DNS servers on the network to work properly.
On iFemtoCell gateway, Wi-Fi access point is available at boot time for one hour, broadcasting an SSID named after its serial number (klk-wifc-XXXXXX
). It can only be used to access the Wanesy SPN iFemtoCell's web user interface (it does not route traffic to anywhere and does not serve as an Internet wireless access point)
The passphrase to connect to this Wi-Fi network is the Ethernet MAC address (it can be found on the Wirnet iFemtoCell label), in uppercase, without spaces between the digits, e.g. 7076FFYYYYYY
.
Your computer may take some time to get the “connected” status, and the interface will have a “limited connectivity”, which is normal.
The home web interface is accessible at the following address:
Gateway model | Address |
---|---|
Wirnet iFemtoCell | http://klk-wifc-XXXXXX/ |
Wirnet iStation | http://klk-wiis-XXXXXX/ |
Wirnet iFemtoCell-evolution | http://klk-fevo-XXXXXX/ |
Where XXXXXX
are the last 6 digits of board id.
Example:
Address to be used with the gateway owning the following label: http://klk-wifc-03002e/
(case insensitive)
Once login screen displayed enter following login/password:
user: spn
password: spnpwd
To have all the features of Wanesy SPN firmware, a license file is needed.
Administration ⇒ License
menu
For security reasons, Kerlink strongly advises its customers to change the default password.
Administration ⇒ Gateway ⇒ Change password
The region where the gateway will be used needs to be configured.
Configuration ⇒ Region
menu and select the region
Save configuration
button
Gateway hardware contains 2 RF radios (0.8 MHz bandwidth for each radio). 8 multi SF channels and 1 mono SF channel can be configured on these 2 radios.
Rx configuration example (all channels enabled and configured):
Configuration ⇒ Rx configuration
menuSave configuration
buttonEnd-device must be registered before receiving any data
Fleet ⇒ End-devices ⇒ Manage end-devices
menu
Override default Rx parameters
if needed
Add end-device
button
Fleet ⇒ Received data
to display Rx data sent by the registered end-device. Click on Refresh
button if needed (bottom right corner of the page)
You can now register to Wiki update notifications: