Check your license version

 SRVLIC-SPN00   SPN V1 for Wirnet Station
 SRVLIC-SPN01   SPN V1 for Wirnet Ifemtocell
 SRVLIC-SPN2*   SPN V2 for Wirnet Ifemtocell / iStation / Ifemtocell-Evolution
 

If you have SRVLIC-SPN01 SPN V1 for Wirnet Ifemtocell gateway you must use the following Wiki: Wirnet iFemtocell SPN.

If you have SRVLIC-SPN00 SPN V1 for Wirnet Station gateway you must use the following Wiki: IoT Station SPN.

• Leaflet : commercial_leaflet_wanesy_spn_v2.5.pdf
  

Ethernet is available on all gateways but Wi-Fi only available on iFemtoCell model.

If ethernet is used, the gateway needs DHCP and DNS servers on the network to work properly.

On iFemtoCell gateway, Wi-Fi access point is available at boot time for one hour, broadcasting an SSID named after its serial number (klk-wifc-XXXXXX). It can only be used to access the Wanesy SPN iFemtoCell's web user interface (it does not route traffic to anywhere and does not serve as an Internet wireless access point)

The passphrase to connect to this Wi-Fi network is the Ethernet MAC address (it can be found on the Wirnet iFemtoCell label), in uppercase, without spaces between the digits, e.g. 7076FFYYYYYY.

Your computer may take some time to get the “connected” status, and the interface will have a “limited connectivity”, which is normal.

The home web interface is accessible at the following address:

Where XXXXXX are the last 6 digits of board id.

Example: Address to be used with the gateway owning the following label: http://klk-wifc-03002e/ (case insensitive)

Once login screen displayed enter following login/password:
user: spn
password: spnpwd

• Wanesy SPN firmware installation: click here
• Wanesy SPN firmware upgrade: click here
• Wanesy SPN firmware uninstall: click here

To have all the features of Wanesy SPN firmware, a license file is needed.

• Go to Administration ⇒ License menu
• Drag and drop license file or click on the panel to upload the license file

For security reasons, Kerlink strongly advises its customers to change the default password.

• Go to Administration ⇒ Gateway ⇒ Change password
• Update password

The region where the gateway will be used needs to be configured.

• Go to Configuration ⇒ Region menu and select the region
• Validate the modification with the Save configuration button

Gateway hardware contains 2 RF radios (0.8 MHz bandwidth for each radio). 8 multi SF channels and 1 mono SF channel can be configured on these 2 radios.

Rx configuration example (all channels enabled and configured):

• Go to the Configuration ⇒ Rx configuration menu
• Configure radio activation and frequency
• Configure channels activation and frequency used by end-device
• Validate the modification with the Save configuration button

End-device must be registered before receiving any data

• Go to the Fleet ⇒ End-devices ⇒ Manage end-devices menu
• Fill the information of the end-device to register. Override default Rx parameters if needed
• Validate the end-device with the Add end-device button

• Go to Fleet ⇒ Received data to display Rx data sent by the registered end-device. Click on Refresh button if needed (bottom right corner of the page)

You can now register to Wiki update notifications:

1. Click on the envelope icon (Manage subscriptions) on the right side of the page.
2. Choose your option and Subscribe.
3. Check your subscription by click again on the envelope icon.