Setup of Wirnet™ iZeptoCell Cellular Gateway

• Leaflet (contains the list of accessories): commercial_leaflet_wirnet_izeptocell_cellular_v3.4.pdf
  
• Wanesy® Cellular Connectivity leaflet: wanesy-cellular_connectivity_commercial_leaflet_v1.0.pdf
• Quick start guide: quick_start_guide_-_izeptocell_cellular_v2.pdf
• Installation recommendations: Gateways installation recommendations
• Cellular connectivity offering: flyer_cellular_connectivity_offering_avs_kerlink_2023.pdf

• Zero Touch Provisioning (ZTP)

You can connect a PC directly to the Wirnet iZeptoCell with a USB cable. In this mode, the gateway will simulate an ethernet device.
In nominal case, after few seconds, your PC will obtain an IP address and you will be able to start a SSH client or HTTP connection on gateway IP 192.168.120.1.
In particular case you are using a DHCP server on your computer, gateway will directly obtain an IP address. A connection can then be done on this IP address.
See here for more information about SSH/HTTP connection details.

Once connected through USB cable, connection to the gateway can either be done via:

• SSH: click here.
• Web Interface: click here.

If needed the factory reset of the gateway is feasible. Consult the stock restore process: click here

To simplify the log gathering process, Kerlink developed automatic log gathering methods. Consult the Automatic log gathering chapter: click here

• Please contact Kerlink Support team at support@kerlink.fr to get a Magic Link to update the gateway with the relevant firmware and embedded applications.
• How to connect a gateway to WMC?

Kerlink is a member of LoRa Alliance and the Kerlink gateway is compatible with LoRaWAN protocol. If you need information about LoRaWAN network protocol please contact the LoRa Alliance and request LoRaWAN specification : https://lora-alliance.org/lorawan-for-developers

You can register for Wiki update notifications by clicking on the envelope icon (“Manage subscriptions”) on the right side of the page.

Administrative information