User Tools

Site Tools


wiki:firmware:release_1.8.0

Wanesy Wave firmware v1.8.0 (Feb. 2021)

Changes from previous version

New features

  • Support of multiple regional parameters: EU868, IN865, US915, AS923, AU915.
  • Dynamic configuration of region.
  • Use unconfirmed TX on LoRaWAN services.
  • Add possibility to change LoRaWAN frame period by configuration.
  • Introducing the CBOR configuration file device.cfg, to get and post parameters values.
  • Add UUID iBeacon filter.
  • Possibility to identify BLE Tags with MAC address or Major/Minor.
  • Wi-Fi updates over HTTP.
  • Wi-Fi access point SSID based on EUI.
  • Limit duration of Wi-Fi access point availability to 45 cycles of BLE scan period.
  • Add control of limit values for parameters.

Evolutions

  • Avoid erroneous CBOR frame sent sometimes.
  • Major/minor configuration is now persistant after a power cycle.

Restrictions

  • Optout_klk SSID is used on the first boot after a factory reset command.
  • Switching filter (mac address or major/minor ) can stop BLE radio transmission. Workaround is to trigger a remote reboot command or manual reboot.
  • During configuration update, out of range values are replaced by “0”.

Firmware

Compatibility

Hardware

This release is compatible with the following Wanesy Wave revision:

  • Wanest Wave 868:
    • Fully compatible with Wanesy Wave Board ID xxxDAcxxxxxx, xxxDAdxxxxxx, xxxDAexxxxxx.
  • Wanesy Wave 915:
    • Fully compatible with Wanesy Wave Board ID xxxDBcxxxxxx, xxxDBdxxxxxx, xxxDBexxxxxx, xxxDBfxxxxxx .

Software

  • STM32 MCU firmware Ver. 1.8.0
  • ESP32 MCU firmware Ver. 1.8.0

Delivery

The firmware is released in two files: STM32 MCU firmware binary 'part' file and ESP32 MCU firmware binary file.

STM32 MCU :
To update the firmware, follow instruction on the Firmware update section of the Setup page: click here.

ESP32 MCU:
To update the firmware, follow instruction on the Firmware update section of the Setup page: click here.

Download

Wifi: firmware update

Wifi: region configuration

History

  • 1.8.0 (Frebuary 2021):
    • Support of multiple regional parameters.
    • Use unconfirmed TX on LoRaWAN services.
    • Wi-Fi update over HTTP.
    • Access Point SSID personal identification based on EUI.
    • Limit duration of Wi-Fi access point availability.
  • 1.7.0 (June 2020):
    • Initial release for Wanesy Wave.
wiki/firmware/release_1.8.0.txt · Last modified: 2021/05/04 10:23 by mbi