Setup of Wirnet™ iZeptoCell Ethernet Gateway

• Leaflet (contains the list of accessories): commercial_leaflet_wirnet_izeptocell_ethernet_v2.0.pdf
  
• Quick start guide: quick_start_guide_izeptocell_ethernet_v5.pdf
• Web services documentation: click here
  
• Software architecture: click here
• Installation recommendations: Gateways installation recommendations

• Zero Touch Provisioning (ZTP)

Connection to the gateway can either be done via:

• SSH: click here.
• Web Interface: click here.
• Local connection
  You can connect a PC directly to the Wirnet iZeptoCell with a USB cable. In this mode, the gateway will simulate an ethernet device.
  In nominal case, after few seconds, your PC will obtain an IP address and you will be able to start a SSH client or HTTP connection on gateway IP 192.168.120.1.
  In particular case you are using a DHCP server on your computer, gateway will directly obtain an IP address. A connection can then be done on this IP address.
  See here for more information about SSH/HTTP connection details.

Use the FAQ chapter “How to read the software version”: click here
First official version compatible with Wirnet iZeptoCell is version 5.5.4.

• Go on the KerOS firmware last version page: click here.
• On the bottom of the page download the liveburner IPK file. This upgrade will factory reset the gateway and upgrade it with the last version. The current configuration is erased.

• Go on the KerOS firmware last version page: click here.
• On the bottom of the page download the KerOS IPK file.
• If specific files need to be preserved consult the upgrade information page: click here.

Update of the gateway's firmware can be done over Network, USB or Web interface. Use the previously downloaded IPK file (liveburner or KerOS) and follow the indication of the dedicated page Software updates: click here.

Kerlink provides a packet forwarder (CPF) compatible with Wirnet iZeptoCell gateways. A packet forwarder is the main program of a LoRa gateway. It has to be installed and configured to implement a LoRaWAN network.

Packet forwarder is included in the firmware. The CPF does not need to be installed. The CPF needs to be enable. To consult how to enable the CPF: click here.

Once the packet forwarder is activated on the gateway, it must be configured to be functional.

• Go on the Kerlink Common Packet forwarder page and select your CPF version: click here.
• On the CPF configuration page look at the chapter “How to configure and monitor the packet forwarder?”

If needed the factory reset of the gateway is feasible. Consult the stock restore process: click here

To simplify the log gathering process, Kerlink developed automatic log gathering methods. Consult the Automatic log gathering chapter: click here

• Please contact Kerlink Support team at support@kerlink.fr to get a Magic Link to update the gateway with the relevant firmware and embedded applications.
• How to connect a gateway to WMC?

See AWS LNS configuration tool

See TTN LNS configuration tool

See Loriot LNS configuration tool

How to connect a gateway to ChirpStack?

Kerlink is a member of LoRa Alliance and the Kerlink gateway is compatible with LoRaWAN protocol. If you need information about LoRaWAN network protocol please contact the LoRa Alliance and request LoRaWAN specification : https://lora-alliance.org/lorawan-for-developers

You can register for Wiki update notifications by clicking on the envelope icon (“Manage subscriptions”) on the right side of the page.

Administrative information