N.B: The BSCC/SNMP package is used for the Wirnet Stations that are static-IP or GSM assigned. See Restrictions/Know issues section below.

• [wifc] JIT LBT feature

• [KerOS] Integration of firmware v3.4.5

• embedded v3.0.1:
  • [Dashboard] - Temperature values are not available for Wifc
  • Autoconnect VPN doesn't work when we unplug & replug ethernet
  • Static IP config is deleted with Megapackage 2.3.3 (IBTS) and 2.3.4 (iFemto)
  • [netctl] Bad firewall rules causing TLS handshake error
  • upgrading HAL from 4.1.3-klk8 to 4.1.3-klk11 is not possible due to incompatibility problems (keros)

• embedded v3.0.2:
  • [KerOS] Use of a single thread to apply network changes

• embedded v3.0.3:
  • [Update] IBTS stays KO at the end of an update

• embedded v3.0.4:
  • BSCC statically checks vpn0 and may trigger unnecessary reboots

• embedded v3.0.5:
  • [KerOS] since FW 3.4.5 discovery failure leading to connection error

• embedded v3.0.6:
  • [KerOS] Discovery failure leading to a problem of identification of the gateway
  • [KerOS] The route to server must also take part of interface name
  • [KerOS] Wrong status of update
  • [KerOS] Accept multiple instances of VPN
  • [KerOS] Fix file descriptors leaking
  • [KerOS] Replace opkg list by opkg list-installed command
  • [KerOS] On installation, check if file already exists before attempting to modify it
  • [KerOS] Apply WLAN password of current ssid if any change
  • [iBTS] Fix bearer identifier
  • [KerOS] Use of a single thread to apply network changes
  • [configuration] Improvements when setting manual IP. Add threads to wait a little all parameters changes before applying them
  • [backup/restore] Force default rollback value to 30 minutes
  • [Wirnet Station] restart openVPn when changes on network interfaces
  • [KerOS] workaround: add force reboot after removing files
  • [KerOS] reset VPN: replace call of netctl by DBus functions
  • [Wista] at first execution get current configuration
  • [KerOS] at first execution get current configuration
  • Detection of first execution of bscc
  • [ntp] Update configuration when configuration changed by external mechanisms (local interface, manual configuration)
  • bscc and SNMP module configurations are updated when occurs external change:
  • [KerOS] Update network addressing (modification of/etc/network/connman/lan.config)
  • [KerOS] Update bearers priority (modification of /etc/network/connaman/main.conf)
  • [KerOS] Update GPRS provisionning (modification of /etc/network/ofono/provisioning)
  • [Wirnet Station] Update GPRS provisionning (modification of /etc/sysconfig/network)
  • [KerOS] openVPN tunnel monitoring
  • [KerOS][wifc] Use imx temperature sensor as temperature
  • [Wifc] LED 2 “Backhaul” is not managed
  • [KerOS] Fix interface info used for connection to WMC
  • [KerOS] Fix bearer priority
  • [KerOS] Modification of firewall rules
  • [KerOS] Add ofono provisionning and connman wifi provionning
  • [Wifc] Add LoRa modem
  • Replace fifos by sockets for local communication

• embedded v3.0.7:
  • [Wista] GPS locking is resolved for DIFFERENTIAL and ESTIMATED GPS location fix

• embedded v3.0.8:
  • [KPI] “Percentage of uplink messages in error” is inverted
  • [Wista] gsm provisioning from dashboard is not taken into account on gateway

• embedded v3.0.9:
  • Add DNS configuration on static IP ethernet backhaul

• embedded v3.0.10:
  • Fix issue: openVPN clients rejected after openVPN server restarts

• embedded v3.0.11:
  • Fixing issue in GSM config: when ugrading the iBTS with the megapackage v3.0.10 sometimes we are losing the WMC connexion in GSM mode
  • [keros] Change default autoquit delay from 3 to 10 for packet forwarder configuration
  • [keros] Change default OpenVPN key renegociation period to 7 days

• Static IP configuration:
  • see FAQ - Static IP configuration to know how to configure static IP for your gateway.
• GSM configuration:
  • see FAQ - GSM configuration to know how to configure GSM for your gateway.
• Software upgrade:
  • see FAQ - Gateway Software Upgrade for WMC 3.x to know how to upgrade a gateway that is static-IP or GSM assigned in order to not loose the network configuration.
• On Wirnet iFemtoCell, spectrum is NOT available.
• For KerOS products, the backup restore (kerosd -b) is not correctly managed (caution: WMC connectivity may be lost).
• On Wirnet Station and KerOS products, the priority of backhaul is not managed. Ethernet is always managed as priority 1.

Legend:

[Wista]= Wirnet Station
[KerOS]= Wirnet iBTS and Wirnet iFemtoCell
[Wifc]= Wirnet iFemtoCell